Thank you for purchasing your new Turbosmart Boost Tee. This new model now has some great new features. These include:
The option of either a slow boost ramp rate for sensitive setups or fast depending on Boost Tee configuration. This is achieved with
either the restricted nipple as well as ball and spring. A wider boost adjustment range for wastegates with low spring base pressures. A new mounting bracket to make it easier to mount. IMPORTANT NOTES ON YOUR BOOST CONTROLLERUse only silicone hose that is the correct size and pressure rating for your application when fitting your boost controller – other hoses
will be affected by heat and will eventually crack or split which could cause excessive boost pressure and engine damage
Ensure that all plumbing is secured with clamps or cable ties. Your boost controller should be mounted at least 100mm from any heat sourceA Turbosmart Fuel Cut Defender may need to be used in conjunction with your boost controller – refer to www.turbosmart.com.au
The boost dial has a left handed thread, be sure not to over tighten as this will damage the boost controller.
Please note that the one turn (click) of the boost controller dial does NOT correspond to 1 PSI change in boost pressure.
RECOMMENDATIONS Turbosmart recommends that the Air Fuel ratio is checked once boost pressure is set Turbosmart recommends that boost pressure is set using a Dynamometer and not on the street Turbosmart recommends that an accurate boost gauge be permanently fitted to the vehicleTurbosmart recommends that your boost controller is fitted and adjusted by an appropriately qualified technician
HOW TO INSTALL YOUR BOOST CONTROLLER TOOLS REQUIRED General mechanic tools Internal Wastegate Setup Allow the engine to cool down before installing your boost controllerLocate the pressure source port and the wastegate actuator port on the turbocharger assembly (refer drawing 1)
Remove the factory boost control solenoid if fitted from the boost pressure supply port while leaving the solenoid connected to the
Install your boost controller in the wastegate pressure line with the wastegate arrow pointing towards the wastegate actuator
If your wastegate actuator has additional ports, these will need to be blocked Secure all silicone hose ends with hose clampsMount your boost controller bracket onto the vehicle, then attach the boost controller onto the bracket with the supplied screws